Installation
INSTALLATION
PROCEDURE
1. INSTALL METER MIRROR WIRE
(a) Engage the clamp and claw.
(b) Connect the connector to install the meter mirror wire.
2. INSTALL METER MIRROR SUB-ASSEMBLY
(a) Install the meter mirror sub-assembly with the 3 screws.
3. INSTALL DEFROSTER NOZZLE ASSEMBLY
Click here
4. INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT
Click here
5. INSTALL NO. 1 SIDE DEFROSTER NOZZLE DUCT
Click here
6. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
Removal
REMOVAL
CAUTION / NOTICE / HINT
The
necessary procedures (adjustment, calibration, initialization or
registration) that must be performed after parts are removed and
installed, or replaced during headup display (meter mirror sub-assembly)
removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|
*: When performing learning using the Techstream.
Click here  |
|
Disconnect cable from negative (-) battery terminal |
Perform steering sensor zero point calibration |
Lane Departure Alert System (w/ Steering Control) |
|
|
Pre-collision System |
|
Intelligent Clearance Sonar System* |
|
Lighting System (for Gasoline Model with Cornering Light) |
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
Panoramic View Monitor System |
|
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|
*: When performing learning using the Techstream.
Click here |
|
Disconnect cable from negative (-) auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane Departure Alert System (w/ Steering Control) |
|
|
Pre-collision System |
|
Intelligent Clearance Sonar System* |
|
Lighting System (for HV Model with Cornering Light) |
|
Memorize steering angle neutral point |
Parking Assist Monitor System |
|
|
Panoramic View Monitor System |
|
CAUTION:
Be sure to read Precaution thoroughly before servicing.
for Gasoline Model: Click here
for HV Model: Click here
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
Click here
2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT
Click here
3. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT
Click here
4. REMOVE DEFROSTER NOZZLE ASSEMBLY
Click here
5. REMOVE METER MIRROR SUB-ASSEMBLY
| (a) Remove the 3 screws and meter mirror sub-assembly. |
|
6. REMOVE METER MIRROR WIRE
| (a) Disconnect the connector. | |
(b) Disengage the claw and clamp to remove the meter mirror wire.
