Toyota Avalon (XX50): Seat Memory Switch

Components

COMPONENTS

ILLUSTRATION

Inspection

INSPECTION

PROCEDURE

1. INSPECT SEAT MEMORY SWITCH (DRIVER DOOR)

(a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition If the result is not as specified, replace the seat memory switch (driver door). 4 - 1 M1 switch pressed Below 1 Ω M1 switch not pressed 10 kΩ or higher 3 - 1 M2 switch pressed Below 1 Ω M2 switch not pressed 10 kΩ or higher 5 - 1 SET switch pressed Below 1 Ω SET switch not pressed 10 kΩ or higher

*a SET Switch *b M1 Switch *c M2 Switch *d Component without harness connected (Seat Memory Switch (Driver Door))

Installation

INSTALLATION

PROCEDURE

1. INSTALL SEAT MEMORY SWITCH

(a) Engage the 4 claws to install the seat memory switch to the front door trim board sub-assembly LH.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here

Removal

REMOVAL

PROCEDURE

1. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Click here

2. REMOVE SEAT MEMORY SWITCH

(a) Using a screwdriver with its tip wrapped with protective tape, disengage the 4 claws to remove the seat memory switch from the front door trim board sub-assembly LH.

*a Protective Tape