Components
COMPONENTS
ILLUSTRATION
|
*1 | LUGGAGE COMPARTMENT DOOR COVER |
*2 | LUGGAGE COMPARTMENT DOOR INSIDE HANDLE |
|
*3 | LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY |
*4 | LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY |
|
*5 | LUGGAGE COMPARTMENT DOOR LOCK |
- | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |
 |
MP grease |
Inspection
INSPECTION
PROCEDURE
1. INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
(a) Check the operation of the door lock motor.
| (1) Move the door lock to the close (lock) position. |
 |
|
*a | Close (Lock) | |
*b | Open (Unlock) | |
*c | Component without harness connected
(Luggage Compartment Door Lock Assembly) | | |
(2) Apply auxiliary battery voltage to the door lock motor and check the operation of the door lock motor.
OK:
|
Auxiliary Battery Connection |
Result |
| Auxiliary battery positive (+) → Terminal 1
Auxiliary battery negative (-) → Terminal 2 |
Luggage compartment door lock motor open (unlock) operation |
If the result is not as specified, replace the luggage compartment door lock assembly.
(b) Check the operation of the luggage compartment door courtesy switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|
2 - 3 | Closed (Locked) |
10 kΩ or higher |
|
2 - 3 | Open (Unlocked) |
Below 1 Ω |
If the result is not as specified, replace the luggage compartment door lock assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY
(a) Install the luggage door lock control cable sub-assembly.
2. INSTALL LUGGAGE COMPARTMENT DOOR INSIDE HANDLE
(a) Connect the cable.
(b) Engage the 2 claws to install the luggage compartment door inside handle.
(c) Engage the claw as shown in the illustration.
 |
Install in this Direction |
3. INSTALL LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
(a) Apply MP grease to the sliding parts of the luggage compartment door lock assembly.
(b) Install the luggage compartment door lock assembly with the 2 bolts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(c) Connect the luggage door lock control cable sub-assembly to the luggage compartment door lock cylinder assembly.
(d) Engage the clamp.
(e) Connect the connector.
4. INSTALL LUGGAGE COMPARTMENT DOOR COVER
Click here 
Removal
REMOVAL
PROCEDURE
1. REMOVE LUGGAGE COMPARTMENT DOOR COVER
Click here 
2. REMOVE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
| (a) Disconnect the connector. | |
(b) Disengage the clamp.
(c) Disconnect the luggage door lock control cable sub-assembly from the luggage compartment door lock cylinder assembly.
(d) Remove the 2 bolts and luggage compartment door lock assembly.
3. REMOVE LUGGAGE COMPARTMENT DOOR INSIDE HANDLE
(a) Disengage the claw as shown in the illustration.
 |
Remove in this Direction |
| (b) Disengage the 2 claws. | |
(c) Disconnect the cable to remove the luggage compartment door inside handle.
4. REMOVE LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSEMBLY
| (a) Remove the luggage door lock control cable sub-assembly. |
|
