Components
COMPONENTS
ILLUSTRATION
|
*1 | ECO SWITCH ASSEMBLY (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) |
- | - |
Inspection
INSPECTION
PROCEDURE
1. INSPECT ECO SWITCH ASSEMBLY (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
|
*a | Component without harness connected (ECO Switch Assembly (Electric Parking Brake Switch Assembly)) |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Switch Condition |
Specified Condition |
|---|---|---|
|
G24-11 (ECU) - G24-16 (GND1) |
ECO switch assembly (electric parking brake switch assembly) off (switch not pressed) |
100 kΩ or higher |
|
G24-11 (ECU) - G24-16 (GND1) |
ECO switch assembly (electric parking brake switch assembly) on (switch pressed) |
Below 10 Ω |
(b) Check that the switch illuminates.
(1) Battery voltage to the ECO switch assembly (electric parking brake switch assembly) and check that the switch illuminates.
OK:
|
Tester Connection | Specified Condition |
|---|---|
|
Battery positive (+) → 3 (ILL+) Battery negative (-) → 7 (ILL-) |
Illuminates |
Installation
INSTALLATION
PROCEDURE
1. INSTALL ECO SWITCH ASSEMBLY (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
Click here 
Removal
REMOVAL
PROCEDURE
1. REMOVE ECO SWITCH ASSEMBLY (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
Click here 
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Heating / Air Conditioning: Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT MG CLT RELAY (for 2GR-FKS) *a MG CLT Relay (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 3 - 5 Battery voltage applied between terminal 1 a ...
