On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT MG CLT RELAY (for 2GR-FKS)
|
*a | MG CLT Relay |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
3 - 5 | Battery voltage applied between terminal 1 and 2 |
Below 1 Ω |
|
3 - 5 | Battery voltage not applied between terminal 1 and 2 |
10 kΩ or higher |
If the result is not as specified, replace the MG CLT relay.
2. INSPECT PTC HEATER RELAY (for A25A-FXS)
|
*a | PTC Heater Relay |
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
3 - 5 | Auxiliary battery voltage applied between terminal 1 and 2 |
Below 1 Ω |
|
3 - 5 | Auxiliary battery voltage not applied between terminal 1 and 2 |
10 kΩ or higher |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Automatic Transaxle System: Pressure Control Solenoid "B" Actuator Stuck Off (P07757F)
DESCRIPTION Based on signals from the transmission revolution sensors (NT and NC), the actual gear is detected. The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical malfunctions of the solenoid valves, transmission valve body assembly and automatic transaxl ...