Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
Before replacing the certification ECU (smart key ECU assembly), refer to Registration.
for Gasoline Model:
Click here 
for HV Model:
Click here
PROCEDURE
1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Engage the 2 claws to install the certification ECU (smart key ECU assembly) as shown in the illustration.
 |
Install in this Direction |
NOTICE:
Make sure that the certification ECU (smart key ECU assembly) is securely installed.
2. INSTALL ECU INTEGRATION BOX RH
Click here
3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Click here
4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
Removal
REMOVAL
CAUTION / NOTICE / HINT
The
necessary procedures (adjustment, calibration, initialization, or
registration) that must be performed after parts are removed and
installed, or replaced during certification ECU (smart key ECU assembly)
removal/installation are shown below.
Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|
*: When performing learning using the Techstream.
Click here  |
|
Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
|
Pre-collision system |
|
Intelligent clearance sonar system* |
|
Lighting system (for Gasoline Model with Cornering Light) |
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
Panoramic view monitor system |
|
|
Replacement of certification ECU (smart key ECU assembly) |
Code registration (Smart key System (for Start Function) |
- Wireless door lock control system
- Smart key system (for Entry Function)
- Smart key system (for Start Function)
- Steering lock function
|
|
Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link |
|
*: When performing learning using the Techstream.
Click here |
|
Disconnect cable from negative auxiliary battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
|
Pre-collision system |
|
Intelligent clearance sonar system* |
|
Lighting system (for HV Model with Cornering Light) |
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
Panoramic view monitor system |
|
|
Replacement of certification ECU (smart key ECU assembly) |
Code registration (Smart key System (for Start Function) |
- Wireless Door Lock Control System
- Smart Key System (for Entry Function)
- Smart Key System (for Start Function)
- Steering lock function
|
|
CAUTION:
Some
of these service operations affect the SRS airbag system. Read the
precautionary notices concerning the SRS airbag system before servicing.
for Gasoline Model:
Click here
for HV Model:
Click here
PROCEDURE
1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
2. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
Click here
3. REMOVE ECU INTEGRATION BOX RH
Click here
4. REMOVE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
(a) Disengage the 2 claws and remove the certification ECU (smart key ECU assembly) as shown in the illustration.
 |
Remove in this Direction |
NOTICE:
- If the ECU integration box RH is deformed or damaged, replace it.
- Do not bend the 2 claws more than necessary.
