Toyota Avalon (XX50): Ptc Heater Assembly

Components

COMPONENTS

ILLUSTRATION

*1	NO. 1 AIR DUCT	*2	NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
*3	NO. 2 HEATER COVER	*4	QUICK HEATER ASSEMBLY
	N*m (kgf*cm, ft.*lbf): Specified torque	●	Non-reusable part

Inspection

INSPECTION

PROCEDURE

1. INSPECT QUICK HEATER ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Installation

INSTALLATION

PROCEDURE

1. INSTALL QUICK HEATER ASSEMBLY

(a) Install the quick heater assembly as shown in the illustration.

Install in this Direction

2. INSTALL NO. 2 HEATER COVER

(a) Engage the claw and 2 guides.

(b) Install the No. 2 heater cover with the screw.

(c) Engage the clamp.

(d) Connect the 2 connectors.

3. INSTALL NO. 1 AIR DUCT

for Manual Tilt and Manual Telescopic Steering Column:

Click here

for Power Tilt and Power Telescopic Steering Column:

Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

Removal

REMOVAL

PROCEDURE

1. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

2. REMOVE NO. 1 AIR DUCT

for Manual Tilt and Manual Telescopic Steering Column:

Click here

for Power Tilt and Power Telescopic Steering Column:

Click here

3. REMOVE NO. 2 HEATER COVER

(a) Disconnect the 2 connectors.

(b) Disengage the clamp.

(c) Remove the screw.

(d) Disengage the claw and 2 guides to remove the No. 2 heater cover.

4. REMOVE QUICK HEATER ASSEMBLY

(a) Remove the quick heater assembly as shown in the illustration.

Remove in this Direction