Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE FRONT LENS HOLDER LH
| (a) Using a screwdriver with its tip wrapped with protective tape, disengage the claw and guide to remove the front lens holder LH. |
|
2. REMOVE FRONT LENS HOLDER RH
HINT:
Use the same procedure as for the front lens holder LH.
3. REMOVE VANITY LIGHT BULB
(a) Remove the 2 vanity light bulbs from the visor assembly.
4. INSTALL VANITY LIGHT BULB
(a) Install the 2 vanity light bulbs to the visor assembly.
5. INSTALL FRONT LENS HOLDER LH
| (a) Engage the guide and claw to install the front lens holder LH. |
|
6. INSTALL FRONT LENS HOLDER RH
HINT:
Use the same procedure as for the front lens holder LH.
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Evaporative Emission System Pressure Sensor/Switch Circuit Short to Ground (P045011,P045015,P04502F)
DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P045011 Evaporative Emission System Pressure Sensor/Switch Circuit Short to Ground EVAP pressure is less than 42.110 kPa(abs) [6.106 psi(abs)] for 0.5 seconds or more. Canister pump module Connector/wire harness ...